Woodworking membrane vacuum press machine for cabinet productionGeneral Introduction:
It is used to work with various high-quality PVC, high gloss, hot transfer and veneer at one side. Mainly press the cabinet,wardrobe,and other furniture.
The products are of high quality, and will not peel off,the line and groove are clear.
This machine can choose loading pressure two times mode by silicon rubber sheet to improve the products quality.
1.vacuum pump,adopting German technology, its horsepower is strong, and long service life.
2.The main engine of hydraulic pressure system adopts international advanced system.The plate plug-in principle features advanced structure, low malfunction rate, high flow and rapid pressure (pressing time about 5 seconds instead of traditional pressing time 15-20 seconds) thus promoting production efficiency.
3.The operation system chooses the international branded "Delta" PLC control equipment and the large man-machine touch screen . The machine is easy to control, and the technology is highly advanced. The automatic degree is very high.
4.The machine frame is made up of 6 whole pieces of armor plates excavated to avoid welding deformation.Techinical Specifications:
5. 2 sets 8 rollers PVC supports,2 set automatic cutters,1 pc partition wall,hook knife and trimming cutter.
|Exterior size :
|Working plate size :
|| 3000mm×1320mm(inner size)
|Maximum products size:
|Maximum height of the work piece :
|| 50mm(including the bottom support)
|Rating working pressure:
|General Power :
|Actual power consumption :
1.Sandard sea freight package, iron wire fixation.
2.Package size:3.8×2.25×2.05m; 2.46×1.25×1.9m, need one 20′ container.
1. Suppy the installation manual books, videos, and on line assistant the customers install,commissioning,and operate.
2. Send our engineers to customers’ factories.
3. Spare parts for customers’ stock.
My factory establised in 1997,professionally manufacture vacuum press machine and profile wapping machine,over 100 workers,more than10 rich experiences after service team,5 technical R & D engineers.